Find help with bricklaying and rendering around Pakenham.

Masonry retaining walls in Pakenham

Plan a brick or block retaining wall in Pakenham: soil, drainage, engineering, permits and boundary questions to settle before a bricklayer quotes.

Masonry retaining walls in Pakenham

Illustrative image, not a completed customer project.

A retaining wall holds back soil where the ground level changes. On sloping blocks in Pakenham 3810, Pakenham Upper and Beaconsfield, masonry retaining walls are used to create flat lawns, driveways and building pads. Because they resist constant soil and water pressure, design comes before bricklaying. This page explains what to sort out first.

Why retaining walls are different

A freestanding garden wall mainly carries its own weight and wind. A retaining wall carries the sideways push of the soil behind it, which increases sharply with height. Water in that soil adds more pressure. If the soil is clay that swells when wet, the load changes with the seasons.

Retaining walls that fail usually do so slowly at first. They lean, bulge, crack horizontally or open at the joints. Eventually a section can topple. A collapse can damage property next door, a driveway or a house footing, and it can injure people. That is why many councils and building surveyors treat retaining walls more carefully than other garden walls.

Masonry options

Several masonry systems are used for retaining walls. A bricklayer or landscaper can explain which suits your site.

System How it works Typical notes
Reinforced concrete block (core filled) Hollow blocks with steel bars and grout in the cores, on a reinforced footing Common for taller walls and those near structures, usually engineered, often rendered
Solid brick retaining wall Thick brick construction, sometimes with piers Used for low walls and garden terraces; limited height without reinforcement
Segmental retaining blocks Interlocking dry-stacked units, often with geogrid reinforcement Usually installed by landscapers to manufacturer designs
Brick-faced wall on a block core Structural block wall with a brick skin for appearance Gives a face brick look with block strength

Concrete sleeper and timber walls are also common in the area but are not masonry and are usually built by landscapers or fencing contractors. This page concentrates on brick and block.

Engineering and soil

Most retaining walls above a modest height, and any wall supporting a driveway, building, pool or boundary, are commonly designed by a structural or geotechnical engineer. The design sets the footing size, reinforcement, wall thickness, drainage and backfill. The bricklayer then builds to that design.

The engineer may need soil information. Soils around Pakenham vary widely, from sandy loams to reactive clays, and the hills toward Pakenham Upper can include weathered rock. A soil test or site investigation may be part of the process. Ask the provider whether they work with an engineer they can recommend, or whether you should engage one directly.

Masonry design in Australia is covered by AS 3700. You do not need to read it, but an engineered design should state the standards it relies on.

Drainage is half the job

Water trapped behind a retaining wall is one of the main reasons walls fail. A well-built masonry retaining wall usually includes:

  • A slotted drainage pipe (ag pipe) at the base behind the wall, wrapped or bedded in gravel
  • Free-draining gravel backfill behind the wall rather than heavy clay
  • Geotextile fabric to stop fine soil clogging the gravel
  • Weep holes or outlets through the wall to release water
  • A place for the collected water to go, such as a stormwater pit or legal point of discharge

Ask the provider where the drainage water will end up. Pointing it at a neighbour’s property or onto a footpath causes problems. Connection to the stormwater system may need a licensed plumber. Cardinia Shire Council can advise on the legal point of discharge for your property.

Permits and boundaries

Retaining walls can need a building permit depending on their height, their position relative to boundaries and buildings, and whether they support a surcharge such as a driveway or a structure. Planning permits can also apply in some overlays. Check with Cardinia Shire Council or a registered building surveyor before work starts. The Building and Plumbing Commission has owner guidance on permits and on checking whether a practitioner is registered.

Walls on or near a boundary affect your neighbour. Changing the ground level near a boundary can redirect water onto their land or undermine their fence. Talk to your neighbour early. If the wall replaces or supports a dividing fence, the Fences Act 1968 sets out the notice and cost-sharing process for dividing fences in Victoria.

Excavation and services

Building a retaining wall involves digging, sometimes a lot of it. Before excavating, lodge a Before You Dig Australia request to locate registered underground services. Private pipes and cables on your land will not be shown, so mark what you know: sewer and stormwater lines, gas, irrigation, garden lighting.

Excavation near an existing house footing or a neighbour’s structure needs care. The engineer’s design should address it. Spoil removal is often a significant part of the cost of a retaining wall, so ask how much soil will be removed or reused.

Questions to put to a provider

When you speak with a bricklayer about a retaining wall, ask:

  1. Does this wall need engineering, and who arranges it?
  2. What type of masonry do you recommend, and why?
  3. How will drainage be handled behind and through the wall?
  4. Where will the drainage water discharge?
  5. Who obtains the building permit, if one is required?
  6. How will you manage excavation near boundaries, fences and footings?
  7. Is spoil removal and backfill included?
  8. Will the wall be rendered, capped or left as face block or brick?

Keep the answers. The bricklaying quote checklist helps compare quotes on the same scope.

Existing walls that are failing

If an existing retaining wall is leaning, bulging or cracking, take photos, measure the lean if you can, and keep people away from the base. Check whether drainage outlets are blocked and whether water is pooling behind the wall. A failing retaining wall often needs engineering advice before repair, because rebuilding it the same way may repeat the failure.

Some repairs are possible, such as rebuilding a section, adding drainage or adding buttresses. Others mean replacing the wall. The brickwork repairs page covers general masonry repairs, but retaining wall failures should be looked at with the retained soil in mind.

Finishing and appearance

Block retaining walls are commonly rendered to match a house or painted. Brick-faced walls can match house bricks. Capping finishes the top and sheds water away from the wall. Plan the finish early because some renders need the wall to cure first, and some finishes need specific preparation. The rendering and finishes page has detail on render options.

Think about what sits on top of the wall. A fence on top of a retaining wall adds wind load and needs to be allowed for in the design. A garden bed directly behind the wall keeps soil wet, which adds pressure. Driveways and parking near the top add load too.

Timing and weather

Excavation and footing work is best done in dry weather. Clay sites around Pakenham can become difficult to work after rain, and open excavations can collapse or flood. Ask the provider how they manage an open trench if rain is forecast and how long each stage takes. Concrete footings and core fill need curing time before backfilling.

Sloping blocks around Pakenham

Retaining walls are most often needed on sloping blocks in Pakenham Upper, Beaconsfield Upper and parts of Officer, and on estates where building pads have been cut into the slope. The Pakenham Upper area page has more on hillside properties. Flat rural land toward Koo Wee Rup and Nar Nar Goon needs fewer retaining walls but has its own drainage considerations.

Terracing a slope with several low walls

Instead of one tall retaining wall, some owners terrace a slope with two or more lower walls stepped back from each other. Terracing can be easier to build, gives garden beds between the walls and may avoid some of the requirements that apply to taller walls. It is not automatically simpler, though. The upper wall can load the soil behind the lower one, so the spacing between them matters. An engineer may treat closely spaced terraces as one tall wall.

If you are considering terraces, ask the provider or engineer how far apart the walls need to be, how each will drain, and whether the lower wall must be designed for the upper one. Plan access too. Mowing and maintaining narrow terraces on a steep slope can be harder than it looks on paper.

Inspecting a retaining wall over its life

A masonry retaining wall needs occasional checks like any other part of the property. Once a year, and after very heavy rain, walk along the wall and look for:

  • Water flowing from weep holes and drainage outlets after rain, which shows the drainage is working
  • Outlets that stay dry or are blocked by soil, roots or debris
  • New cracks, especially horizontal ones or cracks that widen toward the top
  • Any lean or bulge, which you can check with a long straight edge or a string line
  • Soil washing out from under the base or around the ends
  • Trees or large shrubs establishing close behind the wall

Keep a photo record from the same positions each year. Slow changes are easy to miss without one. If a wall starts to move, get advice early, because repairs are much simpler before a wall has rotated or cracked badly.

Questions to settle with a hillside provider

Before a job starts on a sloping block, agree on a few practical points with the provider. Where will spoil from excavation go, and can it be reused on site? How will materials get from the truck to the work area, and is there a risk of damaging the driveway? Who arranges any tree trimming needed for access? What happens if rock or poor ground is found once digging starts, and how will that be priced? What protection will stop soil and cement washing downhill during rain? Clear answers in writing reduce the chance of disputes on a job where conditions often change once the ground is opened up.

Request help

Describe your retaining wall project through the retaining wall enquiry form. Include the height and length you expect, what sits above and below the wall, the soil if known, whether you have an engineering design, and photos of the slope. We share it with up to three independent local masonry businesses, any of which may get in touch to discuss design, permits and price. The provider you choose contracts with you directly. Yes Right Pty Ltd operates this referral site and does not design or build walls.

Send an enquiry